OBDii Installation
  • Sign in

    • OBDii Installation


    How to Plug an OBDII GPS Tracker into a Typical North American Vehicle

    Step-by-Step Guide

    1. Locate the OBDII Port
      • Under the Dashboard (Driver’s Side): The most common location is under the dashboard, near the steering column or pedals.
      • Around the Center Console: Some vehicles have the port near the center console, under the radio, or in the armrest area.
      • Side of the Dashboard: Occasionally, the port is located on the side of the dashboard, visible only when the driver’s door is open.

    2. Prepare the Vehicle
      • Turn Off the Ignition: Ensure the car is off before plugging in the device for safety.
    3. Plug in the OBDII GPS Tracker
      • Align and Insert: Align the connector of the OBDII GPS tracker with the port and insert it firmly.
      • Turn the Ignition to “ON”: Turn the ignition to the “ON” position without starting the engine. This activates the car’s electrical system, allowing the device to communicate with the vehicle’s onboard computer.
    4. Allow the Device to register itself 
      • Device Initialization: The device will begin its initialization process by looking for GPS satellites and connecting to the cell network. This process may take up to 30 minutes.

    Location Guide

    1. Under the Dashboard (Driver’s Side) 
    2. Around the Center Console 
    3. Side of the Dashboard 

    By following these steps, you can easily connect an OBDII GPS tracker to your vehicle and start monitoring its location and performance. If you have trouble locating the port, refer to your vehicle’s owner’s manual or search online for your specific make and model